SciCan Statim 2000 Manual del operador descargar pdf (Pagina 41)

7. Internal Printer (Not on all models)

2. Place the printed wiring board back into position on the printer door. Note the

alignment of the mounting holes

in the wiring board and the mounting bosses

on the printer door. The black plastic printer body rests between the locating ribs

on the inside of the printer door.

3. Ensure that the flexible cables

are not pinched between the printer door

and the wiring board.

4. Place the printer cover on the printer door. Ensure that the flexible cables are not

pinched between the cover and the door. The power button and the paper advance

button must protrude through the openings in the cover and operate freely.

5. Using a #1 Phillips screwdriver, secure the printer cover to the printer door with

the three screws retained during the disassembly procedure. Do not over-tighten

these screws.

6. Plug your Statim 5000 into the wall receptacle. Turn the power switch to the ON

position.

7. Press the printer power button to the ON position. Load paper into the printer

following the procedures in Section 7.1 Installing Paper on the Internal Printer.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 47 48 49

Sin comentarios

SciCan Statim 2000 Manual del operador Pagina 41